+49 (0) 6021 / 40 27-0

Lifting hoops

Cast-in lifting hoop type AS 0.8 - AS 25.0

Cast-in lifting hoops convince by their simplicity and use in various concrete elements, such as wall-like elements, columns, bar-shaped elements, beams and girders. Used wire-rope is bonded and forms a loop which encloses a concrete core – thus it enables high load-bearing capacities for this transport anchor type. A special lifting device is not required for transport and mounting of the elements. Moreover, Cast-in lifting hoops also offer high performance at a low price and thus combine many advantages.

Cast-in lifting hoop type AS 28.0 - AS 95.0

If very heavy or massive concrete elements (hall girders and beams, columns, bridge elements etc.) have to be lifted, transported and mounted, the use of Cast-in lifting hoops for the heavy load range up to 95 t capacity is obvious. Used wire-rope is bonded and forms a loop which encloses a concrete core – thus it enables very high load-bearing capacities for this transport anchor type. Although this heavy-duty anchor is always combined with an individual design service from PHILIPP, the Cast-in lifting hoop in this application area is nevertheless convincing with an unbeatable price / performance ratio.

Wire protection pulley

The Wire protection pulley is an accessory for the Cast-in lifting hoop and is used to protect the wire resp. to ensure the capacity of the anchor during lifting. It is available as a steel or high quality plastic (POM) version and avoids a strong deformation of the wire rope caused by too small radii at the loading point.

Cast-in lifting box

With a flexible end anchorage, the Cast-in lifting box shows its potential especially in wall elements with fragile structural areas, such as slender webs or narrow lintel areas. The easy handling and direct attachment without a lifting device offer a low-price and high-performance solution for small to medium-sized reinforced concrete elements. With the combination of know-how in connection technology and mechanisms of common transport anchors, an anchor type with the usual high quality and safety standards is available.

Loop anchor with offset

The Loop anchor has been developed for light, thin-walled and possibly stackable elements. With a deep anchorage and a little offset, this anchor adapts to the geometric conditions and allows a direct attachment without any special lifting device.

Polypropylene lifting hoop

The loop made of Polypropylene (PP) is the cheap and simple solution for lifting of small slab-like or wall-like precast concrete elements. Due to the additional anchorage reinforcement to be planned, a load capacity up to 1.2 t per anchor is possible. A special lifting device is not required for transport and mounting of the elements.

Angled loop

The application of the Angled loop is focused on light, slab-like precast concrete elements, hollow core floors etc. This anchor type, which is easy to install and to fix to the reinforcement, can be used without a special lifting device. The unbeatable price/performance ratio of the Angled loop makes it very attractive for precasters.