Nailing plate for diagonal tension
Focus of this system is the recess former SZ15, which allows the transport anchor to be inclined by 15°, thus eliminating the need for an additional diagonal tension reinforcement.
Lifting loop with threaded end
For the complete range of PHILIPP Threaded transport anchors the Lifting loop with threaded end, consisting of a galvanised wire rope, can be used for axial and diagonal tension.
Lifty
For a daily use in the precast plant or on the construction site the Lifty is a robust and universally applicable lifting device for the PHILIPP threaded anchor system. It consists of a forged ring bolt with a welded chain link, both galvanised.
Lifty DS
The Lifty DS with wire rope is a universally applicable lifting device for the PHILIPP threaded anchor system. It consists of a forged ring bolt with a thread and galvanised pressed-steel wire rope.
Marking ring with clip
A marking ring identifies a threaded anchor in installed condition and fixes the position of an additional reinforcement by its clip.
Marking ring
Both, the identification of a threaded anchor in installed condition as well as a quick assignment to the corresponding lifting device is done by the marking ring with its color-code.
Sealing cap (plastic)
Sealing caps (plastic) close threaded inserts of all sizes independent of a recessed or surface-flush installation of the anchor.
Lifting loop plus
For all load directions, axial, diagonal and lateral tension, and in combination with the complete range of PHILIPP Threaded transport anchors the Lifting loop plus can be used universally.